Multipin relay support in WLED (change usermods/esp32_multistrip/NpbWrapper.h )

Multipin relay support in WLED (0.11)

Add the following code in usermods/esp32_multistrip/NpbWrapper.h after:
#ifndef RLYPIN
  #define RLYPIN -1  //pin for relay, will be set HIGH if LEDs are on (-1 to disable). Also usable for standby leds, triggers,...
#endif


#ifndef RLYPIN2
  #define RLYPIN2 -1  //pin for relay2, will be set HIGH if LEDs are on (-1 to disable). Also usable for standby leds, triggers,...
#endif

#ifndef RLYPIN3
  #define RLYPIN3 -1  //pin for rela3, will be set HIGH if LEDs are on (-1 to disable). Also usable for standby leds, triggers,...
#endif

#ifndef RLYPIN4
  #define RLYPIN4 -1  //pin for relay4, will be set HIGH if LEDs are on (-1 to disable). Also usable for standby leds, triggers,...
#endif

#ifndef RLYPIN5
  #define RLYPIN5 -1  //pin for relay5, will be set HIGH if LEDs are on (-1 to disable). Also usable for standby leds, triggers,...
#endif

#ifndef RLYPIN6
  #define RLYPIN6 -1  //pin for relay6, will be set HIGH if LEDs are on (-1 to disable). Also usable for standby leds, triggers,...
#endif

#ifndef RLYPIN7
  #define RLYPIN7 -1  //pin for relay7, will be set HIGH if LEDs are on (-1 to disable). Also usable for standby leds, triggers,...
#endif

#ifndef RLYPIN8
  #define RLYPIN8 -1  //pin for relay8, will be set HIGH if LEDs are on (-1 to disable). Also usable for standby leds, triggers,...
#endif


And after the following:
#ifndef RLYMDE
  #define RLYMDE 1  //mode for relay, 0: LOW if LEDs are on 1: HIGH if LEDs are on
#endif

Add these lines:

#ifndef RLYMDE2
  #define RLYMDE2 1  //mode for relay2, 0: LOW if LEDs are on 1: HIGH if LEDs are on
#endif

#ifndef RLYMDE3
  #define RLYMDE3 1  //mode for relay3, 0: LOW if LEDs are on 1: HIGH if LEDs are on
#endif

#ifndef RLYMDE4
  #define RLYMDE4 1  //mode for relay4, 0: LOW if LEDs are on 1: HIGH if LEDs are on
#endif

#ifndef RLYMDE5
  #define RLYMDE5 1  //mode for relay5, 0: LOW if LEDs are on 1: HIGH if LEDs are on
#endif

#ifndef RLYMDE6
  #define RLYMDE6 1  //mode for relay6, 0: LOW if LEDs are on 1: HIGH if LEDs are on
#endif

#ifndef RLYMDE7
  #define RLYMDE7 1  //mode for relay7, 0: LOW if LEDs are on 1: HIGH if LEDs are on
#endif

#ifndef RLYMDE8
  #define RLYMDE8 1  //mode for relay8, 0: LOW if LEDs are on 1: HIGH if LEDs are on
#endif