Controller (DS4, Duelsense, Xbox, etc.) Overclock Guide with Secure Boot ON/ENABLED via LordOfMice/Hidusbf

Controller_Overclock_Guide_with_Secure_Boot_Enabled.md

Controller (DS4, Duelsense, Xbox, etc.) Overclock Guide with Secure Boot ON via LordOfMice/Hidusbf for Windows 10/11

Guide created by rstewa35

Update 12/14/24

Removed the registry steps since the drivers are now signed. This should allow you to use hidusbf without affecting secure boot. If you still want to see them, look at the previous revision of this guide.

Warning

Use the guide at your own risk. Read the warnings/risks HERE.

Step 1

• Clone or download this repo: hidusbf.
• Unzip hidusbf.zip
  • If you downloaded the repo as a ZIP file you'll need to unzip hidusbf-master.zip and then hidusbf.zip.
• Inside the hidusbf directory (hidusbf-master/hidusbf/) double-click SweetLow.CER to install the certificate.

Step 2

• Inside the DRIVER directory (hidusbf-master/hidusbf/DRIVER/) run Setup.exe as administrator.
• Click the drop-down menu on the top left of the window and select All.
• Find your controller and click on it, highlighting it in the window.

Step 3

• Click on the Install Service button at the bottom of the window and select yes on the window that pops up.
• In the drop-down menu to the left of Selected Rate at the bottom, select the polling rate you want your controller at (for most people this will be 1000).
• Now, click on the Filter On Device checkbox in the bottom left corner, enabling it.
• Finally, unplug your controller from your computer and then plug it back in.
• It will look like this when you're done:

That's it, you're done!

Removing/Disabling

Disabling the Overclocking

To disable the overclocking, you just need to run setup.exe again and uncheck the Filter On Device checkbox in the bottom left corner.

Completely Removing Hidusbf

To completely remove the Hidusbf driver and/or reinstall the stock Windows driver you need to:

• Go to the DRIVER directory in file explorer (hidusbf-master/hidusbf/DRIVER/)
• Right click the HIDUSBFU.INF file and click on Install

• Restart your computer and you're done!

@rstewa Wow, thanks for super fast reply! I found out what was the issue, it's kinda obvious. I had "Open with" set to notepad on INF files. So I reset the association to default and bam the Install Service now seems to work.

So I did the initial install service and then with the filter checkbox and now it shows correctly I think: https://i.imgur.com/4v1Y72p.png

But, when trying to run XInputTest_1000_Samples.exe or Polling.exe, the two polling tools I found quickly, it acts weird, the Xinput is throwing error and the polling.exe doesn't detect the controller most of the time and when I disconnect/reconnect it shows up but when I run the test it's not working, it's not doing anything. So I can't test if I'm still at 125hz or not :(

At least the controller still works in game :D

Edit: managed to get the polling.exe work, but it's still showing 125hz, no matter what I set in the tool.