BMDA_Help_1

Usage: D:\DataRoot\Projects\blackmagic\src\blackmagic.exe [options]
	-h, --help		This help
	-l, --list		List available supported probes
	-v, --verbosity	<bitmask> Set the output verbosity, some combination of:
						1 = INFO, 2 = GDB, 4 = TARGET, 8 = PROBE, 16 = WIRE
						
	Probe selection options (if used choose one):
	-d, -device		<path> Use a serial device at the given path (Deprecated!)
	-P, probe		<number> Use the <number>th debug probe found while scanning the
                        system, see the output from list for the order
	-s, --serial	<serNumber> Select the debug probe with the given serial number
	-c, --cable		<type> Select the FTDI-based debug probe with of the given
                        type (cable)
						
	General configuration options:
	-n, --number	<scanNum> Select the target device at the given position in the
                        scan chain (use the -t option to get a scan chain listing)
	-j, --jtag		Use JTAG instead of SWD
	-C, --conReset	Connect to target under hardware reset
	-t, --???		Perform a chain scan and display information about the
                        conected devices
	-T, --???		Perform continues read- or write-back of a value to allow
                        measurement of protocol timing. Aborted by ^C
	-e, --extR		Assume external resistors for FTDI devices, that is having the
                        FTDI chip connected through resistors to TMS, TDI and TDO
	-p, --power		Power the target from the probe (if possible)
	-R, --reset		[h] Reset the device. If followed by 'h', this will be done using
                        the hardware reset line instead of over the debug link
	-H, --highLevel	Do not use the high level command API (bmp-remote)
	-M, --Monitor	<string> Run target-specific monitor commands. This option
						can be repeated for as many commands you wish to run.
						If the command contains spaces, use quotes around the
						complete command
	
	SWD-specific options:
	-f, --freq		<frequenct> Set operating frequency for SWD
	-m, --???		<target> Use the given target ID for selection in SWD multi-drop
	
	Flash operation options:
	-E, --Erase		Erase the target device Flash
	-w, --write		Write the specified binary file to the target device
                        Flash (the default)
	-V, --Verify	Verify the target device Flash against the specified
                        binary file
	-r, --read		Read the target device Flash

	Flash operation modifier options:
	-a, --addr		<address> Start address for the given Flash operation (defaults to
                        the start of Flash)
	-S, --???		<number> Number of bytes to work on in the Flash operation (default
                         is till the operation fails or is complete)
	
	<file>			Binary file to use in Flash operations