Using Blynk for more than one DS18B20 sensor

blynkMultipleDS18B20.ico

#include <SimpleTimer.h>
#define BLYNK_PRINT Serial    // Comment this out to disable prints and save space
#include <BlynkSimpleEsp8266.h>
#include <OneWire.h>
#include <DallasTemperature.h>

#define ONE_WIRE_BUS 2        // This is the ESP8266 pin
OneWire oneWire(ONE_WIRE_BUS);
DallasTemperature sensors(&oneWire);

DeviceAddress tempSensor1 = { 0x28, 0xFF, 0x35, 0x11, 0x01, 0x16, 0x04, 0x25 }; // Temperature probe #1
DeviceAddress tempSensor2 = { 0x28, 0xC6, 0x89, 0x1E, 0x00, 0x00, 0x80, 0xAA }; // Temperature probe #2

char auth[] = "fromBlynkApp";
char ssid[] = "ssid";
char pass[] = "pw";

SimpleTimer timer;

int temperature1, temperature2;         // Variables for storing temperatures

void setup()
{
  Serial.begin(9600);
  Blynk.begin(auth, ssid, pass);

  while (Blynk.connect() == false) {
    // Wait until connected
  }

  sensors.begin();
  sensors.setResolution(tempSensor1, 10);   // More on resolutions: http://www.homautomation.org/2015/11/17/ds18b20-how-to-change-resolution-9101112-bits/
  sensors.setResolution(tempSensor2, 10);

  // These timers are used to keep the loop() nice and leak... keeps Blynk from getting flooded.
  timer.setInterval(5000L, sendSensor1);
  timer.setInterval(30000L, sendSensor2);
}

void loop()
{
  Blynk.run();
  timer.run();
}

void sendSensor1() {
  sensors.requestTemperatures();                  // Polls the sensors
  temperature1 = sensors.getTempF(tempSensor1);   // Stores temp in F. Change getTempF to getTempC for celcius.
  Blynk.virtualWrite(1, temperature1);            // Send temp to Blynk virtual pin 1
}

void sendSensor2() {
  sensors.requestTemperatures();
  temperature2 = sensors.getTempF(tempSensor2);
  Blynk.virtualWrite(2, temperature2);
}

скетч не рабочий исправьте данные скетча

скетч не рабочий исправьте данные скетча

Обязательно сначала проверьте адрес каждого датчика. https://gist.github.com/structure7/6c3231af63a69e6aa6c353db8ffab257
Может быть их более новая версия.