You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Here are some terms to mute on Twitter to clean your timeline up a bit.
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
How to remove the osxkeychain from git credentials
This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Simple guide for setting up OTG modes on the Raspberry Pi Zero
Raspberry Pi Zero OTG Mode
Simple guide for setting up OTG modes on the Raspberry Pi Zero - By Andrew Mulholland (gbaman).
The Raspberry Pi Zero (and model A and A+) support USB On The Go, given the processor is connected directly to the USB port, unlike on the B, B+ or Pi 2 B, which goes via a USB hub.
Because of this, if setup to, the Pi can act as a USB slave instead, providing virtual serial (a terminal), virtual ethernet, virtual mass storage device (pendrive) or even other virtual devices like HID, MIDI, or act as a virtual webcam!
It is important to note that, although the model A and A+ can support being a USB slave, they are missing the ID pin (is tied to ground internally) so are unable to dynamically switch between USB master/slave mode. As such, they default to USB master mode. There is no easy way to change this right now.
It is also important to note, that a USB to UART serial adapter is not needed for any of these guides, as may be documented elsewhere across the int
talk given by John Ousterhout about sustaining relationships
"Scar Tissues Make Relationships Wear Out"
04/26/2103. From a lecture by Professor John Ousterhout at Stanford, class CS142.
This is my most touchy-feely thought for the weekend. Here’s the basic idea: It’s really hard to build relationships that last for a long time. If you haven’t discovered this, you will discover this sooner or later. And it's hard both for personal relationships and for business relationships. And to me, it's pretty amazing that two people can stay married for 25 years without killing each other.
[Laughter]
> But honestly, most professional relationships don't last anywhere near that long. The best bands always seem to break up after 2 or 3 years. And business partnerships fall apart, and there's all these problems in these relationships that just don't last. So, why is that? Well, in my view, it’s relationships don't fail because there some single catastrophic event to destroy them, although often there is a single catastrophic event around the the end of the relation