compile4programmer.sh

#!/bin/bash
#
# OpenIPC full firmware file assembler.
# Creates a file suitable for programming a flash chip.
#
# Example:
#   ./compile4programmer.sh uboot.bin uImage rootfs.squashfs 8
#
# Running this command will produce a new binary file
# full4programmer-8MB.bin or full4programmer-16MB.bin
# suitable for flashing with a programmer.
#
# Paul Philippov <[email protected]>
#

if [ $# -lt 4 ]; then
  echo "Usage: $0 <uboot.bin> <kernel.bin> <rootfs.bin> <flash chip size in MB>"
  exit 1
fi

case "$4" in
    8)
        flashsizemb="8MB"
        flashsize=$((0x800000))
        kerneloffset=$((0x50000))
        rootfsoffset=$((0x250000))
        ;;
    16)
        flashsizemb="16MB"
        flashsize=$((0x1000000))
        kerneloffset=$((0x50000))
        rootfsoffset=$((0x350000))
        ;;
   *)
       echo "Unknown flash size. Use 8 or 16."
       exit 2
esac

check_file() {
    if [ ! -f "$1" ]; then
        echo "File $1 not found."
        exit 3
    fi
}

uboot=$1; check_file $uboot
kernel=$2; check_file $kernel
rootfs=$3; check_file $rootfs

tmpfile=$(mktemp)

dd if=/dev/zero bs="${flashsize}" skip=0 count=1 | tr '\000' '\377' > $tmpfile
dd if=$uboot bs=1 seek=0 count=$(wc -c $uboot | awk '{print $1}') of=$tmpfile conv=notrunc status=none
dd if=$kernel bs=1 seek="${kerneloffset}" count=$(wc -c $kernel | awk '{print $1}') of=$tmpfile conv=notrunc status=none
dd if=$rootfs bs=1 seek="${rootfsoffset}" count=$(wc -c $rootfs | awk '{print $1}') of=$tmpfile conv=notrunc status=none
mv $tmpfile "full4programmer-${flashsizemb}.bin"

echo "Done"
exit 0