My user-made profile for Bambu PLA-CF using an ObXidian 0.4mm nozzle on a Bambu P1S, since one wasn't supplied in the factory profiles

Bambu PLA-CF @Bambu Lab P1S 0.4 ObXidian HF nozzle.json

{
    "additional_cooling_fan_speed": [
        "0"
    ],
    "cool_plate_temp": [
        "45"
    ],
    "cool_plate_temp_initial_layer": [
        "45"
    ],
    "filament_change_length": [
        "10"
    ],
    "filament_cost": [
        "34.99"
    ],
    "filament_density": [
        "1.22"
    ],
    "filament_extruder_variant": [
        "Direct Drive Standard"
    ],
    "filament_flush_temp": [
        "0"
    ],
    "filament_flush_volumetric_speed": [
        "0"
    ],
"filament_id": "GFA50",
    "filament_prime_volume": [
        "45"
    ],
    "filament_scarf_gap": [
        "15%"
    ],
    "filament_settings_id": [
        "Bambu PLA-CF @Bambu Lab P1S 0.4  ObXidian HF nozzle"
    ],
    "filament_type": [
        "PLA-CF"
    ],
    "from": "User",
    "inherits": "Bambu PLA Basic @Bambu Lab P1S 0.4  ObXidian HF nozzle",
    "name": "Bambu PLA-CF @Bambu Lab P1S 0.4  ObXidian HF nozzle",
    "nozzle_temperature": [
        "230"
    ],
    "nozzle_temperature_initial_layer": [
        "230"
    ],
    "nozzle_temperature_range_high": [
        "250"
    ],
    "nozzle_temperature_range_low": [
        "210"
    ],
    "slow_down_layer_time": [
        "8"
    ],
    "supertack_plate_temp": [
        "50"
    ],
    "supertack_plate_temp_initial_layer": [
        "50"
    ],
    "version": "2.0.0.89"
}