boot dmesg of NetBSD/evbarm on HP T5325 Thin Client with internal mSATA SSD

NetBSD-HPT5325.log

~
       _   _     .____    
      | |_| |    |  _ \  
      |  _  |    | (_))   
      | |-| |    | |      
      |_| |_|    |_|  ..  
 _   _     ____              _
| | | |   | __ )  ___   ___ | |_ 
| | | |___|  _ \ / _ \ / _ \| __| 
| |_| |___| |_) | (_) | (_) | |_ 
 \___/    |____/ \___/ \___/ \__| 
 ** LOADER **
 ** BOARD: DB-88F6281A-BP LE 

U-Boot 1.1.4 (Jan  8 2010 - 14:03:56) MIC version : 3.4.19-16

U-Boot code: 00600000 -> 0067FFF0  BSS: -> 006CD4E0

Soc: 88F6281 A1 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz 

DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000   size 256MB 
DRAM CS[1] base 0x10000000   size 256MB 
DRAM Total size 512MB  16bit width
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
[1024kB@f8000000] Flash:  1 MB

CPU : Marvell Feroceon (Rev 1)

Streaming disabled 
Write allocate disabled


USB 0: host mode
PEX 0: PCI Express Root Complex Interface
PEX interface detected Link X1
Net:   egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0 
HP>> ide reset; fatload ide 1:1 0x100000 netbsd.ub; bootm 0x100000

Reset IDE: 
Marvell Serial ATA Adapter
Integrated Sata device found
[0 0 0]: Enable DMA mode (6)
  Device 0 @ 0 0:
Model: SM22 Firm: I052 Ser#: (03)5526888-20080228
            Type: Hard Disk
            Capacity: 463.6 MB = 0.4 GB (949536 x 512)
[0 1 0]: Enable DMA mode (5)
  Device 1 @ 0 1:
Model: ADATA SP310                              Firm: 2.3      Ser#: 2D3220001026        
            Type: Hard Disk
            Supports 48-bit addressing
            Capacity: 61057.3 MB = 59.6 GB (125045424 x 512)

reading netbsd.ub

4256192 bytes read
## Booting image at 00100000 ...
   Image Name:   NetBSD/hpt5325 6.1.4
   Created:      2014-05-05  17:00:09 UTC
   Image Type:   ARM NetBSD Kernel Image (uncompressed)
   Data Size:    4256128 Bytes =  4.1 MB
   Load Address: 00008000
   Entry Point:  00008000
   Verifying Checksum ... OK
OK
## Transferring control to NetBSD stage-2 loader (at address 00008000) ...

NetBSD/evbarm (hpt5325) booting ...
Copyright (c) 1996, 1997, 1998, 1999, 2000, 2001, 2002, 2003, 2004, 2005,
    2006, 2007, 2008, 2009, 2010, 2011, 2012
    The NetBSD Foundation, Inc.  All rights reserved.
Copyright (c) 1982, 1986, 1989, 1991, 1993
    The Regents of the University of California.  All rights reserved.

NetBSD 6.1.4 (HPT5325) #21: Tue May  6 02:00:08 JST 2014
	tsutsui@mirage:/r/work/netbsd-6/src/sys/arch/evbarm/compile/HPT5325
total memory = 512 MB
avail memory = 497 MB
mainbus0 (root)
cpu0 at mainbus0: Sheeva 88SV131 rev 1 (ARM9E-S core)
cpu0: DC enabled IC enabled WB enabled EABT branch prediction enabled
cpu0: 16KB/32B 4-way Instruction cache
cpu0: 16KB/32B 4-way write-back-locking-C Data cache
mvsoc0 at mainbus0: Marvell 88F6281 Rev. A1  Kirkwood
mvsoc0: CPU Clock 1200.000 MHz  SysClock 400.000 MHz  TClock 200.000 MHz
mvsoctmr0 at mvsoc0 unit 0 offset 0x20300-0x203ff: Marvell SoC Timer
mvsocgpp at mvsoc0 unit 0 not configured
mvsocrtc0 at mvsoc0 unit 0 offset 0x10300-0x10317: Marvell SoC Real Time Clock
com0 at mvsoc0 unit 0 offset 0x12000-0x1201f irq 33: ns16550a, working fifo
com0: console
com1 at mvsoc0 unit 1 offset 0x12100-0x1211f irq 34: ns16550a, working fifo
ehci0 at mvsoc0 unit 0 offset 0x50000-0x50fff irq 19: Marvell USB 2.0 Interface
usb0 at ehci0: USB revision 2.0
gttwsi0 at mvsoc0 unit 0 offset 0x11000-0x11fff irq 29: Marvell TWSI controller
iic0 at gttwsi0: I2C bus
mvcesa at mvsoc0 unit 0 not configured
mvgbec0 at mvsoc0 unit 0 offset 0x70000-0x73fff: Marvell Gigabit Ethernet Controller
mvgbe0 at mvgbec0 port 0 irq 11
mvgbe0: Ethernet address f4:ce:46:24:b2:ed
ukphy0 at mvgbe0 phy 8: OUI 0x000ac2, model 0x0022, rev. 0
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
mvgbec1 at mvsoc0 unit 1 offset 0x74000-0x77fff: Marvell Gigabit Ethernet Controller
mvgbe at mvgbec1 port 0 not configured
mvpex0 at mvsoc0 unit 0 offset 0x40000-0x41fff irq 9: Marvell PCI Express Interface
pci0 at mvpex0
vendor 0x11ab product 0x6281 (miscellaneous memory, revision 0x03) at pci0 dev 0 function 0 not configured
vendor 0x18ca product 0x0027 (VGA display) at pci0 dev 1 function 0 not configured
mvsata0 at mvsoc0 unit 0 offset 0x80000-0x87fff irq 21: Marvell Serial-ATA Host Controller (SATAHC)
mvsata0: GenIIe, 1hc, 2port/hc
atabus0 at mvsata0 channel 0
atabus1 at mvsata0 channel 1
mvsdio at mvsoc0 unit 0 not configured
uhub0 at usb0: Marvell EHCI root hub, class 9/0, rev 2.00/1.00, addr 1
mvsata0 port 0: device present, speed: 1.5Gb/s
mvsata0 port 1: device present, speed: 3.0Gb/s
wd0 at atabus0 drive 0
wd0: <SM224>
wd0: 463 MB, 942 cyl, 16 head, 63 sec, 512 bytes/sect x 949536 sectors
wd1 at atabus1 drive 0
wd1: <ADATA SP310>
wd1: 61057 MB, 124053 cyl, 16 head, 63 sec, 512 bytes/sect x 125045424 sectors
uhub1 at uhub0 port 1: SMSC product 0x2514, class 9/0, rev 2.00/0.00, addr 2
uhub1: multiple transaction translators
boot device: <unknown>
root device: wd1a
dump device (default wd1b): 
file system (default generic): 
root on wd1a dumps on wd1b
root file system type: ffs
init path (default /sbin/init): 
init: trying /sbin/init
Fri May 16 19:13:48 UTC 2014
Starting root file system check:
/dev/rwd1a: file system is clean; not checking
swapctl: adding /dev/wd1b as swap device at priority 0
Starting file system checks:
Setting tty flags.
Setting sysctl variables:
ddb.onpanic: 1 -> 0
Starting network.
Hostname: hpt5325
IPv6 mode: host
Configuring network interfaces: mvgbe0.
Adding interface aliases:.
Building databases: dev, utmp, utmpx.
Starting syslogd.
Setting date via ntp.
Mounting all filesystems...
Clearing temporary files.
Updating fontconfig cache: done.
Creating a.out runtime link editor directory cache.
Checking quotas: done.
Setting securelevel: kern.securelevel: 0 -> 1
Starting virecover.
Checking for core dump...
savecore: no core dump
Starting local daemons:.
Updating motd.
Starting ntpd.
Starting inetd.
Starting cron.
Fri May 16 19:16:06 UTC 2014

NetBSD/evbarm (hpt5325) (console)

login: