Part1_8x8_ChessBoard_GLCD.ino

//Author: Vivekanand Dhakane
//updated on: 10 June 2020

#include <Wire.h>

#define OLED_I2c_ADDRESS          0x3C
// registers Addresses
#define COMMAND_REG         0x80  // B1000 0000
#define DATA_REG       0x40  // B0100 0000
// commands
#define ON_CMD              0xAF
#define NORMAL_DISPLAY_CMD  0xA6
#define PAGE_ADDRESSING_MODE  0x02

byte data[]= {0x55, 0xAA, 0x55, 0xAA, 0x55, 0xAA, 0x55, 0xAA};
void setup() {

  oled_begin();
  setCursor(0, 0);


//send data in array to display
  for(int i=0; i<8;i++)
  {
      writeData(data[i]);      
  }
  
}


void loop() {
  // put your main code here, to run repeatedly:

}

void oled_begin()
{
  Wire.begin(); // join i2c bus (address optional for master)
  turnON();
  NormalDisplayMode();
  setPageMode();
  writeCommand(0x8d); //Charge Pump
  writeCommand(0x14);
  clearFullDisplay();
}


void writeCommand(byte command) {
  Wire.beginTransmission(OLED_I2c_ADDRESS); // begin transmitting  (OLED_I2c_ADDRESS=0x3C)
  Wire.write(COMMAND_REG);                  // Command Reg Address (COMMAND_REG     =0x80 )
  Wire.write(command);                      // Command to be excuted
  Wire.endTransmission();                   // stop transmitting
}

void writeData(byte data) {
  Wire.beginTransmission(OLED_I2c_ADDRESS); // begin transmitting   (OLED_I2c_ADDRESS=0x3C)
  Wire.write(DATA_REG);                     //Data Reg Address      (DATA_REG        =0x40)
  Wire.write(data);                         //Write data
  Wire.endTransmission();                   // stop transmitting
}

void turnON() {
  writeCommand(ON_CMD);
}
void NormalDisplayMode() {

  writeCommand(NORMAL_DISPLAY_CMD);

}

void setPageMode() {
  byte addressingMode = PAGE_ADDRESSING_MODE;
  writeCommand(0x20);        //set addressing mode
  writeCommand(PAGE_ADDRESSING_MODE);   //set page addressing mode
}



//clearFullDisplay()
// In this function we are setting X,Y=0
// then write data on 128 column and
// then change page and do same till 7th page
void clearFullDisplay() {
  for (byte page = 0; page < 8; page++) {

    setCursor(0, page);
    for (byte column = 0; column < 128; column++) { //clear all columns
      writeData(0x00);
    }

  }
  setCursor(0, 0);
}

void setCursor(byte X, byte Y) {
  writeCommand(0x00 + (X & 0x0F));        //set column lower address
  writeCommand(0x10 + ((X >> 4) & 0x0F)); //set column higher address
  writeCommand(0xB0 + Y);                 //set page address

}