This file contains bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
ESSENTIALS FROM THE CR-30 DISCORD: | |
1. Loosen the small belt connecting the conveyor to its stepper to avoid overheating. | |
2. Remove the conveyor and loosen all the screws on the heat bed plate except the front center by one quarter turn. | |
3. Tape the +5V pin on the USB cable to eliminate potential circuilating currents that may damage the Octoprint Pi. | |
4. Install the "Community Firmware": https://github.com/CR30-Users/Marlin-CR30 | |
5. PID Tune the hot end and bed. | |
6. Tune E-steps. | |
7. Level the bed following Nak3D's YouTube video. | |
8. Tune bed level side-to-side using ???'s repeating leveling pattern. | |
9. Level the bed front-to-back using a leveling wedge. |