Skip to content

Instantly share code, notes, and snippets.

View ReznorsRevenge1's full-sized avatar

Finn Eliot Baltazar ReznorsRevenge1

View GitHub Profile
@ReznorsRevenge1
ReznorsRevenge1 / Pencil Bypass.md
Last active September 15, 2026 22:23
Pencil Method via Soldering Iron

Pencil Bypass

The Pencil Method/Pencil Bypass is an unenrollment vulnerability for Chromebooks. Specifically, it allows disabling hardware write protection regardless of FWMP state by physically powering the write-protect pin on the security chip, usually to set GBB flags while still enrolled. The guides I've seen about this aren't bad, but they involve taking a lot of risk, some of which can be lessened if you have the right tools. So here's how you do it!

Caution

This method is very, very risky. I do not advise doing this unless you know that you know what you're doing, as messing up on anything can & will permanently brick your device. If you:

  • Completely understand what each step says what to do & what it entails, without having to look anything up.
  • Have experience with all of the materials & equipment in this guide.

...then you probably have enough knowledge and confidence to do this. Otherwise, close this tab right now. Either way, I am not responsible for the consequences of

@ReznorsRevenge1
ReznorsRevenge1 / SuzyQable Pin Connection Guide.md
Created May 18, 2026 02:54
A simple guide showing you what pins need to connect to what for a working SuzyQable

SuzyQable Pin Connection Guide

Information online about the proper pin connections are needed for a working SuzyQable are inconstistent, with some people saying that only one configuration works and others saying that only another works. Here's a reference for your sanity. There are two ends of the circuit: the target device's USB-C port (the device that you want to debug), and the male USB-C plug on the otherwise normal USB-C-to-USB-C cable that you're gonna use to debug; this cable will connect to your computer or something. I'll refer to the target USB-C port as the debugee, and to the cable connected to the debugging device as the host.

  • host's A4 should:
    • connect directly to debugee's A4
    • connect through a 22kΩ resistor to debugee's A5
    • connect through a 45.3kΩ resistor to debugee's B5
  • host's A5 should be grounded through a 5.1kΩ resistor
  • host's B5 should be grounded through a 5.1kΩ resistor
  • host's A7 should connect directly to **debuge