bistory

# Ikea Vindriktning
uart:
  rx_pin: 6
  baud_rate: 9600

# SHT21
i2c:
  sda: 8
  scl: 10
  scan: true

bistory

[mcu PIS]
# Obtain definition by "ls -l /dev/serial/by-id/" then unplug to verify
serial: /dev/serial/by-id/xxxx

[adxl345]
cs_pin: PIS:gpio13
#spi_bus: spi1a
spi_software_sclk_pin: PIS:gpio10
spi_software_mosi_pin: PIS:gpio11
spi_software_miso_pin: PIS:gpio12

bistory

0. Système à jour, Klipper à jour et dfu-util installé ( sudo apt-get install dfu-util )

1. Installation de CanBoot

git clone https://github.com/Arksine/CanBoot
cd CanBoot
make menuconfig
make

bistory

1. Flash du Portable Input Shaper

cd ~/klipper

make menuconfig

Choisir Raspberry Pi RP2040

make

bistory

1. Installer le Raspberry Pi comme processus Linux

cd ~/klipper/
sudo cp ./scripts/klipper-mcu.service /etc/systemd/system/
sudo systemctl enable klipper-mcu.service

cd ~/klipper/
make menuconfig

bistory

[gcode_macro LOAD_FILAMENT]
gcode:
    {% set speed = params.SPEED|default(300) %}
    {% set max_velocity = printer.configfile.settings['extruder'].max_extrude_only_velocity %}
    SAVE_GCODE_STATE NAME=load_state
    M300 # beep
    G91
    G92 E0
    G1 E350 F{max_velocity} # fast-load
    G1 E25 F{speed} # purge

bistory

[led_effect logo_idle]
autostart:              false
frame_rate:             24
leds:
    neopixel:sb_leds (1-8)
layers:
    breathing  10 1 top (0,0,.7)

[led_effect critical_error]
leds:

bistory

[gcode_macro CALIBRATE_Z]
rename_existing: BASE_CALIBRATE_Z
gcode:
  STATUS_CALIBRATING_Z
  BASE_CALIBRATE_Z

bistory

#
# This macro comes from VoronFR Discord : https://discord.gg/nmAdtqX6
# Pressure Advance calibration test.
#
# The main reason for this test is that the standard tuning tower provides ambigious, open to interpretation readings with a broad margin for error.
# This test provides control values next to the values being tested, so differences are easier to notice at a glance.
#
# Prints a series of bands, 6 lines per each, with the first 3 lines printed slowly and used as baseline/control and the other 3
# at two different speeds in the following sequence: 25% at 40mm/sec, 50% at 120mm/sec, 25% at 40mm/sec.
# Pressure Advance value is being increased for every band starting from 0.01 with 0.002 increments.

bistory

#####################################################################
#	LED Control
#####################################################################

[neopixel caselight]
pin: PD3
#   The pin connected to the neopixel. This parameter must be
#   provided.
chain_count: 54
#   The number of Neopixel chips that are "daisy chained" to the