capcom-r

https://www.raspberrypi.org/forums/viewtopic.php?f=26&t=31003

capcom-r

RSX Printrbot steps problems? (i.e. parts too big or small?)

Run M503 in Repetier to see steps settings. For our printer, they should match https://printrbot.zendesk.com/hc/en-us/articles/202227454-Default-Steps-Per-Millimeter

EXCEPT! The Z should be 1511.57 not 2272.72 - so that website is wrong.

To make changes, type in M92 X80, and similar for Y, Z, and E. To save, type M500. Can re-check with M503.

capcom-r

So your copter is lifting, but spinning like crazy. That means you have the rotation and prop directions correct because its lifting, but you may have them together wrong. So you may have to actually change the prop and direction for each arm (which would still let it lift up, but not spin). Just make sure you followed the diagram correctly.

capcom-r

Follow these steps (found on Adobe forums, works just fine!):

1. Locate the Edge Inspect MSI installer file that you downloaded.
2. While holding down the Shift key on the keyboard, right-click on the Edge Inspect MSI, then choose Copy As Path.
3. Go to Start > All Programs > Accessories.
4. Right-click on Command Prompt and choose Run As Administrator. This should open a command prompt window, labeled "Administrator:".
5. In the Command Prompt window, type msiexec /i (you need to enter a single space after "/i").
6. Right-click in the Command Prompt window, then choose Paste. This should paste the path to the MSI file that you copied in Step 2 above.
7. Press Enter to run the command.

capcom-r

Watch this video: https://www.youtube.com/watch?v=8NAXSBCtSLY

A few things to remember:

- Don't forget it actually matters which motor you connect to which Mx port on the KK - it must be right depending on your motor layout!
- Don't forget to calibrate the throttle so that all motors start spinning at the same time (as shown in above video) - MAKE SURE BLADES ARE OFF!

capcom-r

To turn on self level without AUX connected, arm with right stick all the way to bottom left. Disarm to see self-level should be on. Arm by moving left stick bottom right, disarm by moving left stick bottom left.