CodingCellist

DISCLAIMER

I am not responsible for any damages, loss of data, system corruption, or any other mishap you may somehow cause by following this guide.

This is mainly a step-by-step reminder/log for myself of how I installed Arch on my laptop. I am putting this out there in case it is useful for someone else, it is not intended to be an official guide. As a result, you may find that this guide is very tedious or lists a lot of unnecessary/intuitive steps or just straight up does things in a way that is considered bad practice. Apart from the latter, this is intentional, as I did not find these steps intuitive at all when

tamas-molnar

alias kc='kubectl'
alias kclf='kubectl logs --tail=200  -f'
alias kcgs='kubectl get service -o wide'
alias kcgd='kubectl get deployment -o wide'
alias kcgp='kubectl get pod -o wide'
alias kcgn='kubectl get node -o wide'
alias kcdp='kubectl describe pod'
alias kcds='kubectl describe service'
alias kcdd='kubectl describe deployment'
alias kcdf='kubectl delete -f'

staltz

The introduction to Reactive Programming you've been missing

(by @andrestaltz)

---

This tutorial as a series of videos

If you prefer to watch video tutorials with live-coding, then check out this series I recorded with the same contents as in this article: Egghead.io - Introduction to Reactive Programming.

---

jafstar

		//ABC JAZZ
		//mp3: "http://listen.radionomy.com/abc-jazz"
		
		//FRISKY FM
		//mp3: "http://scfire-mtc-aa02.stream.aol.com:80/stream/1015"
		http://stream2.friskyradio.com:8000/frisky_mp3_hi
		http://chill.friskyradio.com/friskychill_mp3_high

		//WWOZ 
		//mp3: "http://wwoz-sc.streamguys.com/wwoz-hi.mp3"