Portable Hex Beam - K6LXE

README.md

Portable Hex Beam - K6LXE

THIS IS A VERY EARLY UNREFINED PROTOTYPE -- NO MEASUREMENTS AND TOLERANCES ARE A BIT WACKY

Pictures and measurements are coming soon.

Parts

Center Hub Install Video:

Ramblings:

• Print with PETG, 100% infill. 0.35 mm rough was fine.
• Print 4 quarters (or 2 halves, if you can) of the center piece for the spacer. It wraps around a 1/2 PVC pipe.
• Secure with 2 hose rings
• Insert the Shakespeare Wonderpoles over the center rods
• Place the tip on the top of the PVC pipe (should be about 2 feet from the center).
• Place the middle spacers/bracket on the rods.
• I used nylon #18 "mason twine". Tie a knot at one end, thread through the middle spacer, thread through the tip, then tie to the opposite rod, bending both rods taut. Repeat 3 times.
• Make 6 more equal sizes rope lengths and tie all rods horizontally to each other for stability
• Place the end spacers (for 20m) on the rods.
• Use https://www.hex-beam.com/specs/ for element measurements. I used fishing wire. Gently spread the elements on the spacers. (The 20m elements are very flimsy, since the rods aren't rigid enough at the end)
• Connect the driven element however you choose

parts.zip

Nice Build Congrats !

Thanks for sharing, 73 de PY2XZ

Great job.
Do you plan to use it in the field?

Great job. Do you plan to use it in the field?

I think so! I'm trying to figure out the best way to stow the wires.